Paverpol Art Stone

AT 317

New

A fun product! Art Stone can be used in two different ways. You can use it to make self-hardening clay, or you can use the powder to creat a stone-look finish to your sculptures.  It can also be combined with our new Paversand product to create beautiful 3D effects.

CAD$19.55

Add to wishlist

To make a stone finish, use Paverpol lead color or Paverpol transparent mixed with Pavercolor Siena as a basis. (Of course, you can also mix with other Pavercolors if desired.) You can use a preformed figure of Styrofoam, plaster, paper mache, or kitchen foil covered with masking or floral tape). If you dont like the appearance of a base you can change it completely!

To make a self-hardening clay:
Mix the colored Paverpol with the same amount of Art Stone Decoration Powder until the clay is one lump that no longer sticks to your hands. (Just like a pie dough!)
Cover your form completely with the colored Paverpol. Put the clay fully or partially onto the layer that is still wet—layer thick or thin, coarse or fine, whatever you like. Make sure that the bottom layer is wet. (If needed, apply a new layer of Paverpol using the brush.)
When your work is fully or partially decorated with the clay, scatter some powder over it and rub it in well. Apply some Paverpol with a brush if the base has become too dry. You can also scatter a little Paverpol on the wet layer and rub it afterwards.
This stone effect is not suitable for outdoor objects. If you want to leave the piece of work outside, you can use patina instead of powder, which can be made by mixing white Pavercolor with Josefine gloss varnish. Apply with a brush. Remove the surplus patina with a tissue. Let the work dry and make it glossy with a lint-free cloth.

To make a crackling paste: roll the paste until its no longer sticky ( like a pie dough), scatter some Pavercolors, roll again and delicately stretch the paste to crackle it.

To make a stamped paste: apply your stamp, heavy lace, embossed tapistry, etc, and delicately rub Pavercolors on the surface.

No customer comments for the moment.

Write a review

Paverpol Art Stone

Paverpol Art Stone

A fun product! Art Stone can be used in two different ways. You can use it to make self-hardening clay, or you can use the powder to creat a stone-look finish to your sculptures.  It can also be combined with our new Paversand product to create beautiful 3D effects.